User:Madeleine Y. Bee/Notebook/Single Molecule Fluorescence/2013/06/21

From OpenWetWare
Jump to navigationJump to search
Owwnotebook icon.png Meeting, Absorbance Data Report.pngMain project page
Resultset previous.pngPrevious entry      Next entryResultset next.png

June 21, 2013

Notes from Meeting

  • Check pH of sodium citrate buffer (color change?)
    • Read literature for salt effects on AuNPs
  • Make lower concentration dilutions of DNA/ThT solutions by serial dilutions
    • Plot the ratio rather than the DNA concentration
  • Use the same wavelength for the calibration curve; take zero point (ThT) out of the calibration curve
  • Tuesday: run MB samples on the FCS with Dr Miller
  • Dilute 10x AuNPs@SiO2
    • Read literature for alternative detection methods
  • Endnote

Absorbance Data

Abs data 2013 0621 AuNPs@SiO2 MHA.png<br.> <br.> Abs data 2013 0621 AuNPs@SiO2 20uL.png<br.> <br.> Abs data 2013 0621 AuNPs@SiO2 40uL.png<br.> <br.>


Absorbance spectra, especially those from the silica-coated AuNPs made with MHA and 5uL TES, are consistent with those from the literature (according to Synthesis of Nanosized Gold−Silica Core−Shell Particles). The silica-coated AuNPs show a peak at approximately 525nm.<br.> <br.> Since the AuNPs@SiO2 synthesized with MHA and 5uL TES produced the best spectra, I think I will move onto the DNA attachment procedure using those. Additionally, I'm interested in varying the volume of TES added to see if higher or lower volumes will produce thicker or thinner silica-coatings, respectively (keeping the MHA constant and trying 10uL, 15uL, 20uL). I might also look at the volumes of TES used without MHA: since the higher volume of TES (40uL) did not seem to produce the expected spectra and the lower volume (20uL) did, I'd be interested to see the results of using 30uL, 15uL, 10uL, and 5uL of TES would be.<br.> <br.> A final important note- PBS was used for ALL dilutions in this procedure, and sample were sonicated after dilution before being measured. The salt content of the PBS prevents the nanoparticles from aggregating.

DNA/ThT Solutions

Solutions of 100nM, 200nM and 700nM DNA with 2.5uM ThT were prepared and their fluorescence measured to make a more complete calibration curve (see 06/20/2013). Fluorescence for the 200nM sample observed as expected, but the 100nM was much lower than expected and the 700nM much higher than expected. This inconsistency may be due to incorrect calibration of pipetman. Samples will be made again and run next week.