UV Vis - Testing Beads (cont.)
- Continue with the previous procedure for the 20% and 30% beads
- Start using a pump to suck out water from column because the beads are too fine for water to flow through quickly enough.
- Clean the right end of the pumping tube by letting it pump out clean water (This tube usually has soap inside)
- Connect the pumping tube directly to the column (Figure 1)
- Fill the tube with 5 ml of MG 50 ppm
- Place the left end of the pumping tube at the rim of a vial for collection
- Change the speed to 15 rpm and press start
- Press stop when the solution in the column is totally pumped out (it usually takes minutes)
- Label the vial
|