Difference between revisions of "IGEM:Harvard/2007/Quorum Sensing"

From OpenWetWare
Line 11: Line 11:
==== Transformation of Parts into Top10 ====
==== Transformation of Parts into Top10 ====
Perry [[IGEM:Harvard/2007/Protocols#Transformation|transformed]] the parts [[F1610]], [[I13263]], and [[I13272]] into Top10 cells  
Perry [[IGEM:Harvard/2007/Protocols#Transformation|transformed]] the parts [[F1610]], [[I13263]], and [[I13272]] into Top10 cells  
==== Plating of Parts ====
==== Plating of Parts in Top10 ====
Perry plated the three parts onto three separate petri dishes.
Perry plated the three parts onto three separate petri dishes.
=== 6/26/07 ===
=== 6/26/07 ===

Revision as of 19:27, 26 June 2007

Planned Work

Short Term

  • Midiprep the liquid cultures (6/27/07)
  • PCR (6/27/07)

Long Term

  • Find out what kind of access we have to HSL proteins so we can test the response of the receiver construct at different levels of HSL concentration.
  • Transform the signal and receiver into two OmpA+His constructs. Mix these two constructs with large nickel beads as a test
  • Do something similar to the above idea, except with other OmpA+something constructs

Completed Work


Transformation of Parts into Top10

Perry transformed the parts F1610, I13263, and I13272 into Top10 cells

Plating of Parts in Top10

Perry plated the three parts onto three separate petri dishes.


Growth of colonies in liquid cultures

Alex and George grew a large amount because we want to carry out a midiprep tomorrow

  1. Take 3 500 mL flasks from the cabinet in the big room with the house on the chalkboard and the person saying "Yaye"
  2. Put 150 mL of LB and 150 µL of ampicillin (all the parts are ampicillin resistant) into each flask
  3. Put into the agitating incubator overnight


Initial Plan (6/25/07)

Basically all of the parts that are available are derived from the LuxI/LuxR system found in V. fishcheri. The Voigt paper that we read a long time ago used this system to demonstrate a cell-density dependent expression of invasin in E. Coli (Media:Voigt.pdf).

The basic idea that Perry and I discussed requires two basic parts which Perry transformed into three separate tubes of Top10 cells this afternoon:

  1. An HSL signal sender (BBa_F1610)
  2. An HSL signal receiver attached to a report

(BBa_I13263 or BBa_I13272) The only difference between the two signal receivers is a different YFP reporter protein.

A quick rundown of how it will work: we will stick some sort of promoter in front of the BBa_F1610 in order to produce constitutive expression of HSL. We can play around with which promoter we want to use in order to tweak the sensitivity of the system. This HSL will normally diffuse quickly. Meanwhile, there is constitutive expression of the protein produced after transcription and translation of luxR (called R from now on) is continually going on in the bacteria with the receiver. The HSL will bind to the R and these bound complexes will dimerize and activate transcription of the YFP reporter. However, normally the concentration of HSL is too low and the equilibrium highly favors unbound HSL and R. In areas of high cell concentration, the concentration of HSL will be great enough to shift the equilibrium toward the bound complex. This bound complex will then activate the transcription of the reporter gene. An interesting note is that the bound complex supposedly also represses the luxR gene according to the Biobricks parts list. However, I haven't found any confirmation of this. If it is true, then it means that along with the activation of transcription of the reporter gene the amount of luxR will decrease and transcription of the YFP reporter would probably decrease.

There are a few ways we could approach this:

  1. Have both the signaller and receiver+reporter parts in the same plasmid
  2. Have the signaller part in one plasmid and the receiver+reporter part in another plasmid, both in the same bacterium
  3. Have two different bacteria: one with the signaller part and one with the receiver+reporter part

Perry asked Mike about the first two possibilities and confirmed that both should be doable. The last possibility was demonstrated in the Voigt paper.

I'm not completely sure what the advantages/disadvantages of each system is, but I think we should try all three possibilities.

Also, if we can get this to work, we could potentially build more complex systems that involve logical gates. One example paper (Media:Pulse.pdf) used two bacteria and five separate parts controlled by inducible/repressible promoters two create a pulse of fluorescence.

Additional Ideas (6/26/07)

This is a pretty awesome paper: Constructuion and engineering of positive feedback loops

  • Mentions making LuxR mutants to make them hypersensitive, which would minimize crosstalk ... directed evolution could also be potentially used to enhance the activities of LuxR or alter specificity for a cognate signal molecule.