From OpenWetWare
Jump to: navigation, search

Creating an Anatomical BRIK

Surfaces are created from an anatomical (T1) MRI dataset. Surface creation works best if two or more T1 datasets are acquired and averaged. This can be accomplished with the following commands. Motion correction is applied before averaging in case the subject moved between anatomies.

3dAllineate -base 3DSAG_T1_2.nii -source 3DSAG_T1_1.nii -prefix ${ec}anatr1_1RegTo2 -verb -warp shift_rotate -cost mi -automask -1Dfile ${ec}anatr2toanatr1
3dmerge -gnzmean -nscale -prefix ${ec}anatavg 3DSAG_T1_2.nii  ${ec}anatr1_1RegTo2+orig

If only a single T1 was acquired, then an average dataset can be faked with the command

 3dcopy 3DSAG_T1.nii ${ec}anatavg

The instructions below assume that a dataset named ECanatavg+orig has already been created.


All of the steps below are contained in the scripts file /Volumes/data9/surface/scripts/@prep_dir

To run this command first change into the directory where a subject's anatomy (in AFNI format) is stored in a file name ECanatavg. e.g.

 cd /Volumes/data1/UT/DB/afni

Then, type

 /Volumes/data9/surfaces/scripts/@prep_dir ec subjname

Where ec is the two-letter experiment code and subjname is the subject's name in the format lastname_firstname. The scripts assumes that an anatomical named ECanatavg+orig exists in the current directory. e.g.

 /Volumes/data9/surfaces/scripts/@prep_dir DB doe_jane

This will create surfaces in the directory doe_jane

Initial setup in /surfaces

Make subject directory in /Volumes/data9/surfaces

mkdir lastname_firstname

cd into directory

mkdir afni

copy high resolution scans into afni directory


3dcopy /Volumes/data1/UT/CG/afni/CGanatr1+orig ./CGanatr1

Creating FreeSurfer Directory Structures for Individual Subjects

FreeSurfer requires a specific directory structure for each subject. In addition FreeSurfer requires that subjects’ directories be listed in the $SUBJECTS_DIR. Since this is an environment variable, it can be set at anytime:

set SUBJECTS_DIR = /surfaces/subject_name/ 

The program mksubjdirs constructs the directory structure automatically.

mksubjdirs subjID

Importing AFNI Files into FreeSurfer

The mri_convert program is used to convert the BRIK/HEAD files into the mgz format (gzipped MGH file),:

mri_convert $SUBJECTS_DIR/afni/subjIDanatr+orig.BRIK $SUBJECTS_DIR/subjID/mri/001.mgz

This should be repeated for every anatomical scan with the number scheme 001.mgz, 002.mgz, 003.mgz, etc.


 mri_convert afni/CAavganat+orig.BRIK CA/mri/001.mgz

if the averaging is done in AFNI (recommended method).

Ignore warnings issued by Freesurfer about using only one anatomical scan