| || |
'''Detecting Capsules by Negative Stain'''<BR>
'''Detecting Capsules by Negative Stain'''<BR>
Highly mucoid (sticky and wet) colonies could be tested for the presence of a capsule using the capsule stain protocol
, if you have time to do this. If not, don't worry. This test is of more intellectual interest than useful as evidence for one or more of your investigative goals. The capsule stain protocol is found in the Special Stains section of PROTOCOLS.<Br><BR> |+|
Highly mucoid (sticky and wet) colonies could be tested for the presence of a capsule using the capsule stain protocol if you have time. If , don't worry. This test useful evidence investigative goals . The capsule stain protocol is found in the Special Stains section of PROTOCOLS.<Br><BR>
If your Gram stain results were ambiguous or not what you expected from growth on PEA and EMB
you used, you should probably repeat those Gram stains. |+|
If your Gram stain results were ambiguous or not what you expected from growth on PEA and EMB , you should probably repeat those Gram stains.
| || |
Revision as of 04:29, 2 March 2011
Finding Evidence for Co-operation and Competition Among Cultured Members of a Soil Community
Complete Quorum Sensing & Mutualistic and Antagonistic Interactions Tests set up last week
Analyze your quorum sensing and interactions assays. Take photos for visual evidence of your findings.
Complete Antibiotic Production & Sensitivity Testing
Examine the plates and look for evidence of a zone of inhibition (no growth) of "control" organisms in an area near the putative antibiotic producer's colonial growth. Evidence of antibiotic production should appear as a measurable radius of inhibition (section of a circle of no growth). Use a millimeter ruler to measure the radius of area of no growth and convert that radius to diameter (millimeters of inhibition). The size of the zone of inhibition is indicative of the diffusion potential of the antibiotic and/or an indication of how sensitive the test organism is to the secreted inhibitor. Compare your results to other tested isolates in your lab section. Think about why an antibiotic might work differently on a Gram positive vs. a Gram negative organism or between two bacteria that are both Gram positive.
Take photos of any plates that show evidence of antibiotic producers in your soil community. If you found that your isolates did not appear to cause measurable inhibition of growth, does that mean that your isolate does not secrete any antimicrobial compounds? Why or why not?
SIM TESTS DEVELOPMENT AND ANALYSIS
Motility detection is possible due to the semisolid nature (low concentration of agar) of the SIM medium. Growth radiating out from the central stab inoculation line indicates that the test organism is motile. The motility test should be assessed first. Motile organisms will exhibit growth radiating from the stab inoculation line. Non motile organisms will exhibit growth only along the stab inoculation line. Would it be useful for some soil community members to be motile? Why? Would having motile members in a soil community be useful to non-motile members, or would that mixture be disadvantageous to one or the other, or could it be both?
TEST FOR TRYPTOPHANASE and SULFUR REDUCTION
What functional advantage would bacteria have if they are positive for tryptophanase or able to produce hydrogen sulfite? Would having some soil community members with these functional capacities obviate the need for other members to have the same enzymes? How so? Remember that all metabolic processes are "expensive" in terms of energy and raw materials used. Does this testing give us direct rather than theoretical evidence of a community where members have different metabolic capabilities? Is direct evidence for such co-operation and competition what you seek to answer one of your main investigative questions? Do you see why we are doing these tests?
The ingredients in SIM (sulfate/ indole/ motility) medium enable detection of two such metabolic capabilities that some bacteria have and others lack: digestion of tryptophan by the enzyme tryptophanase to indole and/or sulfur reduction with the production of hydrogen sulfide. SIM medium contains nutrients, iron, and sodium thiosulfate.
The indole test is used for detecting tryptophanase. Casein peptone is rich in tryptophan, which is attacked by certain microorganisms resulting in the production of indole. Bacteria possessing the enzyme tryptophanase cleave tryptophan, producing three end products. One of these end products is indole, produced in aerobic conditions; another is skatole, produced in anaerobic conditions. Amyl alcohol in Kovacs reagent acts as a solvent for indole, which then reacts with p-dimethylaminobenzaldehyde to produce a red rosindole dye. Organisms which do not produce tryptophanase produce no color change in SIM medium when Kovacs is added while bacteria positive for tryptophanase produce a red color when Kovacs reagent is added.
PROTOCOL for DEVELOPING AN INDOLE TEST
To detect indole production due to the enzyme tryptophanase, add three or four drops of Kovacs’ reagent and observe the fluid for development of a ring of red color(positive reaction)at the top of the tube.
DETECTING A POSITIVE H2S test:
The hydrogen sulfide test relies on the use of sodium thiosulfate and ferrous ammonium sulfate as indicators of hydrogen sulfide production. Ferrous ammonium sulfate reacts with H2S gas to produce ferrous sulfide, a black precipitate.
When hydrogen sulfide gas is produced, a precipitation reaction will occur with the ferrous ammonium sulfate. An insoluble black precipitate is seen as a positive result. You will develop/analyze your SIM results in Lab 8.
Approximate Formula* Per Liter
Pancreatic Digest of Casein - 20.0 g
Peptic Digest of Animal Tissue - 6.1 g
Ferrous Ammonium Sulfate - 0.2 g
Sodium Thiosulfate - 0.2 g
Agar - 3.5 g
Kovac's reagent: (per liter)
Amyl Alcohol 750.0 ml
Hydrochloric acid 250.0 ml
Directions for the Schaeffer-Fulton Endospore stain and Capsule negative stain are found in the Protocols section of the wiki.
Stains : Simple, Gram, Endospore, Capsule. The confirmatory tests for motility are found in Protocols under MOTILITY.
All Gram positive bacilli or any bacteria that showed a spore shaped, unstained area in the cells when Gram stained should be stained for endospores. In addition, any Gram positive isolates growing from your dried soil extract on Glyerol Yeast Extract Agar (GYEA) medium should be stained for endospores. There is no need to stain Gram negative isolates for endospores. Would it surprise you to know that most of the spore forming bacteria are common soil organisms? Why would the capacity to form a highly protective, heat tolerant, dessication resistant, non-metabolic spore be useful to soil community microorganisms? Would this capacity give those members a competitive advantage to survive weather extremes? Would you expect a tropical greenhouse habitat to contain relatively fewer or more spore forming members than other habitats?
Confirmatory Tests for Motility
Directions for the Hanging Drop motility test and Flagella stain can be found in the Motility section of Protocols. All bacteria that were positive or ambiguous for motility in SIM medium should be looked at by Hanging Drop technique. Any "swarmers" (bacteria that spread all over the plate when cultured on solid medium)should be looked at by Hanging Drop, too. If the hanging drop test is positive and you have time after you have performed any other confirmation tests or special stains, you could try the Flagella stain, but don't worry if you don't have time for this stain. It is VERY difficult to see flagella even when they are coated with several layers of stain reagent that make the diameter larger. It is hard to get this stain to work well.
Detecting Capsules by Negative Stain
Highly mucoid (sticky and wet) colonies could be tested for the presence of a capsule using the capsule stain protocol if you have time. If you don't have time, don't worry. This test isn't particularly useful in acquiring evidence to fulfill the investigative goals of our project. The capsule stain protocol is found in the Special Stains section of PROTOCOLS.
If your Gram stain results were ambiguous or not what you expected from the growth patterns you observed on PEA and EMB media, you should probably repeat those Gram stains.
Graphical abstract: See models in research reports found in recent issues of the journal Cell
Links to Labs