Annealing primers

From OpenWetWare
Revision as of 16:30, 3 May 2005 by Barry Canton (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

A simple and cheap way to make a short (<100bp) piece of DNA is to order two complementary primers from a company such as Invitrogen.

  • When the primers arrive, redissolve them in 50mM Tris buffer to yield a concentration of ~800ng/Failed to parse (MathML with SVG or PNG fallback (recommended for modern browsers and accessibility tools): Invalid response ("Math extension cannot connect to Restbase.") from server "https://api.formulasearchengine.com/v1/":): {\displaystyle \mu} l.
  • For the annealing mix one recipe that works is as follows -
    • 4Failed to parse (MathML with SVG or PNG fallback (recommended for modern browsers and accessibility tools): Invalid response ("Math extension cannot connect to Restbase.") from server "https://api.formulasearchengine.com/v1/":): {\displaystyle \mu} l of each of the concentrated primers.
    • 4Failed to parse (MathML with SVG or PNG fallback (recommended for modern browsers and accessibility tools): Invalid response ("Math extension cannot connect to Restbase.") from server "https://api.formulasearchengine.com/v1/":): {\displaystyle \mu} l of salt solution (10mM NaCl)
    • 28Failed to parse (MathML with SVG or PNG fallback (recommended for modern browsers and accessibility tools): Invalid response ("Math extension cannot connect to Restbase.") from server "https://api.formulasearchengine.com/v1/":): {\displaystyle \mu} l of water
  • The salt shields the negative charges on the single-stranded DNA molecules, allowing them to come close enough to bind.
  • Anneal the primers by heating them at least 5oC above their melting point and cooling them down slowly in stages using a Thermocycler. Melting Temperature calculations can best be done using software such as VectorNTI or data may come with the primers themselves.
  • A simpler approach is to add the above mix in a PCR tube to a beaker of boiling water and just allow the water to cool down naturally. Most primers pairs with length less than 100bp should be fully melted at 100oC and certainly any non-specific binding should be melted at that temperature.
  • Unless you have ordered your primers with 5' phosphate added you will probably improve the efficiency of any subsequent cloning steps by using adding the 5' phosphate using a protocol such as PNK Treatment of Primers