Sean Lauber:Fibronectin IHC staining

From OpenWetWare

Jump to: navigation, search

1. Cut 3 μM sections, mount on slides, air dry overnight

2. Place slides at 60*C for 40 min

    • Remove the following reagents to warm to RT: UltraAb diluent, H2O2, 5% NGS, Proteinase K, Envision, Acetate buffer

3. Place slides in xylene I for 5 min, then to xylene II for 5 min, then to xylene III for 5 min

    • Prepare the methanol solution, label it

4. Transfer to 100% alc I for 10 sec, then to II for 10 sec, then to III for 10 sec

5. Place into freshly prepare methanol solution for 25 min

6. Transfer to 100% alcohol for 10 sec, then to 95% for 10 sec, then to 70% for 10 sec

7. Wash in running tap water for 5 min

8. Rinse in distilled water for 1 min

9. Place slides onto rack and flood with TBS, let sit for 5 min (covered with TBS)

10. Drain & wipe slides, then add enough drops of Proteinase K to cover samples (about 3 drops - record drops) for 5 min

11. Flood slides 3 times for 5 minutes each with TBS

12. Drain & wipe slides, add enough drops of 5% NGS for 20 min, cover rack

13. Drain & wipe, add enough drops of 0 (d. negative) and 1:200 dilution of fibronectin (Abcam, ab2413) for 1 hr

14. Flood slides 3 times for 5 minutes each with TBS

15. Drain & wipe slides, add enough drop of Envision+-rabbit for 30 min (record number of drops)

16. Flood slides 3 times for 5 minutes each with TBS

17. Place in 0.05 M acetate buffer pH 5.0 for 5 min

18. Place in freshly prepared and filtered chromogen/substrate solution for 15 min

19. Place in running tap water for 5 min

20. Rinse in distilled water and counterstain with Mayer's Hxt for 45 sec

21. Wash in running tap water for 1 min

22. Place in TBS for 1 min

23. Mount sections with glycerin

Personal tools