User:Sarah Burkhard/Notebook/CHEM 481 Polymers/2016/10/28: Difference between revisions
Line 12: | Line 12: | ||
watchglass: 8.83238 g | watchglass: 8.83238 g | ||
with wet beads: 8.87360 g | with wet beads: 8.87360 g | ||
beads wet : | |||
w dry beads: 8.84719 g | |||
beads dry: 0.02641 g | |||
swelling: wet-dry / dry = | |||
*swelling 20 % beads: | *swelling 20 % beads: | ||
watchglass: 8.82765 g | watchglass: 8.82765 g | ||
with wet beads: 8.84342 g | with wet beads: 8.84342 g | ||
w dry beads: 8.83670 g | |||
*swelling 30 % beads: | *swelling 30 % beads: | ||
watchglass w label: 8.83311 g | watchglass w label: 8.83311 g | ||
with wet beads: 8.83633 g | with wet beads: 8.83633 g | ||
==Data Analysis== | ==Data Analysis== |
Revision as of 12:47, 28 October 2016
Project name | <html><img src="/images/9/94/Report.png" border="0" /></html> Main project page <html><img src="/images/c/c3/Resultset_previous.png" border="0" /></html>Previous entry<html> </html>Next entry<html><img src="/images/5/5c/Resultset_next.png" border="0" /></html> |
Entry title
watchglass: 8.83238 g with wet beads: 8.87360 g beads wet : w dry beads: 8.84719 g beads dry: 0.02641 g swelling: wet-dry / dry =
watchglass: 8.82765 g with wet beads: 8.84342 g w dry beads: 8.83670 g
watchglass w label: 8.83311 g with wet beads: 8.83633 g Data Analysis
hence, in future we can get concentration via A/0.0813 . (september 9 )
glass transition: point where stops being malleable (from high low T). between glass transition and melting it's malleable. 10 % clay was crosslinked very well so no melting (straight line i.e. no dip) . bottom line: water leaving. heat of melting crosslinked/ heat not crosslinked = percentage not cross-linked
max. absorbance for each run . in general to derive concentration . get mass of MG in mg that was not absorbed by beads. significant increase , almost exponential. total mg MG added after 35 ml : 1.75 mg capacity of beads: mass MG absorbed / g beads capacity measured vs gram dry beads. per dry mass gives you effective mass. per clay tells you how efficient clay is. capacity of dry beads: multiply by 5.56 (5.56 g wet beads / 1 g dry beads) calculate beads and clay capacity based on mass percentage and total absorbance of MG
concentration increased for Al (only if clay went through) Cu: increases quickly. plateaus around 60 ml after 12th sample. according to calculation, we expected absorbance to decrease after around 30 ml. total amount added Cu - amount coming out = 0.0566 mg absorbed. 1/3 was absorbed by beads. Zn: plateaus at 12 Pb: plateaus at 11 Na: starts high and gets low. significant decrease after first 5 ml. again at 7. minimum at 14 . Ca: less than Na. our clay has more Ca.
|