User:Pranav Rathi/Notebook/OT/2010/08/18/CrystaLaser specifications

From OpenWetWare

(Difference between revisions)
Jump to: navigation, search
(Mode Profile)
(Specs by the Manufacturer)
Line 24: Line 24:
== Specs by the Manufacturer ==
== Specs by the Manufacturer ==
All the laser specs and the manual are in the document:
All the laser specs and the manual are in the document:
-
{{ShowGoogleWord|id=0B5jWjFYiQdkfNDBiMTIwM2UtMDM3OC00NjUyLTlkNzAtMTE0MjA2ZDNlMzc2|width=500|height=300}}
+
[Specs[https://docs.google.com/fileview?id=0B5jWjFYiQdkfNDBiMTIwM2UtMDM3OC00NjUyLTlkNzAtMTE0MjA2ZDNlMzc2&hl=en]]
-
 
+
-
 
+
-
 
+
[[Category:1064crystalaser]]
[[Category:1064crystalaser]]

Revision as of 17:52, 4 November 2010

Contents

Specifications

We are expecting our laser any time. To know the laser more we are looking forward to investigate number of things. These specifications are already given by the maker, but we will verify them.

Polarization

Laser is TM (transverse magnetic) or P or Horizontal linearly polarized. We investigated these two ways: 1) by putting a glass interface at Brewster’s angle and measured the reflected and transmitted power. At this angle all the light is transmitted because the laser is P-polarized, 2) by putting a polarizing beam splitter which uses birefringence to separate the two polarizations; P is reflected and S is transmitted, by measuring and comparing the powers, the desired polarizability is determined. We performed the experiment at 1.8 W where P is 1.77 W and S is less than .03 W*

Beam waist at the output window

We used knife edge method (this method is used to determine the beam waist (not the beam diameter) directly); measure the input power of 1.86W at 86.5 and 13.5 % at the laser head (15mm). It gave us the beam waist (Wo) of .82mm (beam diameter =1.64mm).

Possible power fluctuations if any

The power supply temperature is really critical. Laser starts at roughly 1.8 W but if the temperature of the power supply is controlled very well it reaches to 2 W in few minutes and stay there. It’s really stupid of manufacturer that they do not have any fans inside so we put two chopper fans on the top of it to cool it and keep it cool. If no fans are used then within an hour the power supply reaches above 50 degrees of Celsius and then, not only the laser output falls but also the power supply turns itself off after every few minutes.

Mode Profile

Higher order modes had been a serious problem in our old laser, which compelled us to buy this one. So mode profiling is critical; we want our laser to be in TEM00. I am not going to discuss the technique of mode profiling; it can be learned from this link: [1] [2].

As a result it’s confirmed that this laser is TEM00 mode. Check out the pics:

250pxe

Specs by the Manufacturer

All the laser specs and the manual are in the document: [Specs[3]]

Personal tools