User:Pranav Rathi/Notebook/OT/2010/08/02/x & y Signal Drift Issue: Difference between revisions
From OpenWetWare
Jump to navigationJump to search
Pranav Rathi (talk | contribs) (New page: ===Setup & procedure=== ====Steps==== # Measure the beam waist (2 x W=1.5) at the eyepiece lens of the telescope. # Setup the (1:1) telescope: In this case two planoconvex lenses (f=38.1mm...) |
Pranav Rathi (talk | contribs) (→Steps) |
||
Line 4: | Line 4: | ||
# Setup the (1:1) telescope: In this case two planoconvex lenses (f=38.1mm of both) are used. | # Setup the (1:1) telescope: In this case two planoconvex lenses (f=38.1mm of both) are used. | ||
# Measure the beam waist again (2 x W =1.5) at QPD, to make sure that the ratio is 1:1. | # Measure the beam waist again (2 x W =1.5) at QPD, to make sure that the ratio is 1:1. | ||
# Straighten the beam after the telescope, using two aperture techniques. | # Straighten the beam after the telescope, using two aperture techniques [[http://openwetware.org/wiki/User:Pranav_Rathi/Notebook/OT/2010/04/20/Super_easy_way_to_straighten_and_align_two_laser_beams_simultaneously]]. | ||
# Setup the QPD in the xyz translation stage. | # Setup the QPD in the xyz translation stage. | ||
Revision as of 13:58, 2 August 2010
Setup & procedure
Steps
- Measure the beam waist (2 x W=1.5) at the eyepiece lens of the telescope.
- Setup the (1:1) telescope: In this case two planoconvex lenses (f=38.1mm of both) are used.
- Measure the beam waist again (2 x W =1.5) at QPD, to make sure that the ratio is 1:1.
- Straighten the beam after the telescope, using two aperture techniques [[1]].
- Setup the QPD in the xyz translation stage.