User:Megan L. Channell/Notebook/Masters Research/2013/10/24: Difference between revisions
From OpenWetWare
(Autocreate 2013/10/24 Entry for User:Megan_L._Channell/Notebook/Masters_Research) |
|||
(2 intermediate revisions by the same user not shown) | |||
Line 6: | Line 6: | ||
| colspan="2"| | | colspan="2"| | ||
<!-- ##### DO NOT edit above this line unless you know what you are doing. ##### --> | <!-- ##### DO NOT edit above this line unless you know what you are doing. ##### --> | ||
== | ==PLA Film== | ||
* | * Make Polylactic acid (PLA) film with MOF-5 that was made [[User:Megan L. Channell/Notebook/Masters Research/2013/10/3|here]]. | ||
==Protocol== | |||
#0.1 %, 0.5 %, 1.0 %, 5.0 %, 10 % and 0 % w/v. | |||
##0.1 % - 0.9993 g PLA, 0.0013 g MOF-5, 10 mL dichloromethane | |||
##0.5 % - 0.9951 g PLA, 0.0052 g MOF-5, 10 mL dichloromethane | |||
##1.0 % - 0.9904 g PLA, 0.0099 g MOF-5, 10 mL dichloromethane | |||
##5.0 % - 0.9497 g PLA, 0.0495 g MOF-5, 10 mL dichloromethane | |||
##10.0 % - 0.9000 g PLA, 0.9899 g MOF-5, 10 mL dichloromethane | |||
##0 % - 0.999 g PLA, 10 mL dichloromethane | |||
#Used the ultrasonic to mix each sample in a plastic vial until dissolved completely. | |||
#Once dissolved, poured into molds to set. | |||
==Note== | |||
The 10% is not 10% because there was too much MOF-5. This needs to be re-done. | |||
<!-- ##### DO NOT edit below this line unless you know what you are doing. ##### --> | <!-- ##### DO NOT edit below this line unless you know what you are doing. ##### --> | ||
|} | |} | ||
__NOTOC__ | __NOTOC__ |
Revision as of 13:24, 5 November 2013
Project name | <html><img src="/images/9/94/Report.png" border="0" /></html> Main project page <html><img src="/images/c/c3/Resultset_previous.png" border="0" /></html>Previous entry<html> </html>Next entry<html><img src="/images/5/5c/Resultset_next.png" border="0" /></html> |
PLA Film
Protocol
NoteThe 10% is not 10% because there was too much MOF-5. This needs to be re-done. |