- UVProbe was opened.
- Window > 1. Kinetics
- Methods Icon
- Wavelength: 265nm
- Duration: 300 seconds (5minutes)
- Shimadzu CPS-Controller was set to 25°C.
- wait for the temperature to raise to 25°C
- place the sample in the cell and click start.
- Phosphate buffer was used as a blank and was used to create the baseline.
- A spectrum of 1mM adenosine was taken. The absorbance exceeded the capabilities of the spectrometer, so 100μM adenosine (0.6mL 500μM stock adenosine diluted with 100μM by adding 2.4mL buffer) was used as the maximum concentration.
- Once it was determined that 100μM adenosine created a clear spectra, kinetics was run at 265nm using 2.38mL phosphate buffer, 600μL of 500μM stock adenosine, and 20μL ADA (as outlined in the table above).
- The velocity was determined by clicking Operations > Activity Table > dAbs. The average of the dAbs values is the average slope (velocity).
- Then, an assay was run at 265nm using 2.38mL phosphate buffer, 600μL of 50μM stock adenosine (to make a final concentration of 10μM), and 20μL ADA (as outlined in the table above).
- The absorbance was close to 0, indicating that the ideal adenosine concentration likely ranges between 10μM and 100μM.
- Then, an assay was run at 265nm using 2.38mL phosphate buffer, 600μL of 5μM stock adenosine (to make a final concentration of 1μM), and 20μL ADA (as outlined in the table above).
- From the spectra obtained today, the following tables were created:
- This table is the volumes of 5mM adenosine and phosphate buffer used to make the new adenosine stock solutions.
- This table is the updated table of the volumes and concentrations of solutions that will be added in the cuvette.
|Concentration of Adenosine (uM)
||Average Velocity over 30s (nm/sec)
Lineweaver-Burk Plot of the data obtained today.
| Vmax||0.000249029 nm/sec
| Km||8.93143474 uM