User:Linh N Le/Notebook/2009/08/17: Difference between revisions
From OpenWetWare
(Autocreate 2009/08/17 Entry for User:Linh_N_Le/Notebook) |
|||
(3 intermediate revisions by one other user not shown) | |||
Line 6: | Line 6: | ||
| colspan="2"| | | colspan="2"| | ||
<!-- ##### DO NOT edit above this line unless you know what you are doing. ##### --> | <!-- ##### DO NOT edit above this line unless you know what you are doing. ##### --> | ||
== | ==To Do== | ||
* | * NI bnc module | ||
==DAQ Card== | |||
*Koch got in a new NI BNC module that uses direct wires to hook it up | |||
**A naked wire goes into the port and then you screw it down | |||
*Koch wants me to convert this into BNC | |||
**BNC head on one end and then the naked BNC wires screwed into the device | |||
*We have to shield the exposed wires with both some tape (or shrink wrap) and maybe a box enclosure in the future | |||
**Koch also wants the cables to be ~2ft long | |||
*There may also be a problem with strain relief, so we should find a way to connect all 4 of the connections that Koch wants me to setup | |||
*I have 4 cables attached to the module with BNC heads on one end and wired to AI0, AI1, AI2, AI3, and grounds repectively | |||
*The setup will be sitting near my work area (gel area of wetlab) | |||
*[[User:Steven J. Koch|Steve Koch]] 01:47, 18 August 2009 (EDT): Thank you! | |||
<!-- ##### DO NOT edit below this line unless you know what you are doing. ##### --> | <!-- ##### DO NOT edit below this line unless you know what you are doing. ##### --> | ||
|} | |} |
Revision as of 22:47, 17 August 2009
Project name | <html><img src="/images/9/94/Report.png" border="0" /></html> Main project page <html><img src="/images/c/c3/Resultset_previous.png" border="0" /></html>Previous entry<html> </html>Next entry<html><img src="/images/5/5c/Resultset_next.png" border="0" /></html> |
To Do
DAQ Card
|