User:Karlena L. Brown/Notebook/PVOH Research/2012/11/14

OBJECTIVES

• Standardize 0.2M NaHCO₃ solution with KHP
• Conduct swelling examinations of each film

Standardization Preparation Protocol

1. In a clean burette, pour in the 0.2M NaHCO₃ solution until it reaches the top
2. Turn the stopcock at the bottom of the burette to allow the solution to pass through the tip
3. In a clean beaker, run the solution from the burrette until 0.2M NaHCO₃ solution volume reaches the 0.00mL calibration mark
4. Record the initial starting point and then turn on the stir plate beneath the burette
5. Next, place a new dry 10mL beaker containing a small stir bar onto the stir plate
6. While stirring, add ~1g of dry KHP crystals to the beaker
7. Next, add ~2 drops of bromothymol blue indicator
8. Begin titrating by turning the stopcock on the burette allowing the 0.2M NaHCO₃ solution to steadily stream out
9. Slow the pace of the 0.2M NaHCO₃ solution to drops when the PVOH solution begins to turn red in color
10. Once the solution completely to turns red, stop titrating by turning the stopcock to OFF position
11. Record the new 0.2M NaHCO₃ volume within the burette

REPEAT THE ABOVE STEPS AGAIN FOR THE NEXT TWO KHP SAMPLES

Standardization Calculations

Standardization Calculations

Swelling Test Protocal

Swelling Test Result Analysis

Notes

• Due to so much 0.2M NaHCO₃ solution used for titration, in regards to standardization, the amounts of dried KHP needed to be re-evaluated. Only thirds of the original amounts measured out were be used for standardization.
• Instead of taking three measurements for standardization, four measurements were taken because one trial of results was thrown out due to inaccurate measurements -- indication / equilibrium point was underestimated (trial #1).