User:Ellen Petersen/Notebook/MOF Continued/2013/04/02

From OpenWetWare

(Difference between revisions)
Jump to: navigation, search
(Autocreate 2013/04/02 Entry for User:Ellen_Petersen/Notebook/MOF_Continued)
Line 6: Line 6:
| colspan="2"|
| colspan="2"|
<!-- ##### DO NOT edit above this line unless you know what you are doing. ##### -->
<!-- ##### DO NOT edit above this line unless you know what you are doing. ##### -->
-
==Entry title==
+
==DPNI==
-
* Insert content here...
+
 
 +
* 1.) Add solids 1,4,5,8 Naphthalenetetracarboxylic dianhydride (.4025 g, 3.00 mmol) and 4-aminopyridine (.4235 g, 6.00 mmol)to round bottom flask
 +
* 2.) Add 75 mL of solvent (DMA) ~keep under hood~
 +
* 3.) Add Stir Bar to solution
 +
* 4.) Put under spout and raise black knob until there is enough pressure to hold it in place
 +
* 5.) Begin to stir
 +
* 6.) If attached to condenser, turn on water very slightly
 +
* 7.) Turn on nitrogen: ensure bubbles are about 1 every 4 seconds. (Turn little end of nossle up)
 +
* 8.) Turn on heat to 40, switch down accordingly until it reaches 135 degrees consistently.
 +
______________________________________________________________________________________________________
 +
 
 +
04-03-13
 +
 
 +
* 9.) Turn off nitrogen and water, Cool to Room Temperature
 +
* 10.) Filter out solid using diethyl ether
 +
* 11.) NMR in Chloroform (See Image Below)
 +
 

Revision as of 11:46, 28 June 2013

Project name Main project page
Previous entry      Next entry

DPNI

  • 1.) Add solids 1,4,5,8 Naphthalenetetracarboxylic dianhydride (.4025 g, 3.00 mmol) and 4-aminopyridine (.4235 g, 6.00 mmol)to round bottom flask
  • 2.) Add 75 mL of solvent (DMA) ~keep under hood~
  • 3.) Add Stir Bar to solution
  • 4.) Put under spout and raise black knob until there is enough pressure to hold it in place
  • 5.) Begin to stir
  • 6.) If attached to condenser, turn on water very slightly
  • 7.) Turn on nitrogen: ensure bubbles are about 1 every 4 seconds. (Turn little end of nossle up)
  • 8.) Turn on heat to 40, switch down accordingly until it reaches 135 degrees consistently.

______________________________________________________________________________________________________

04-03-13

  • 9.) Turn off nitrogen and water, Cool to Room Temperature
  • 10.) Filter out solid using diethyl ether
  • 11.) NMR in Chloroform (See Image Below)



Personal tools