Synthetic Biology:Vectors/Single copy plasmid
Design and fabricate a single copy vector in which BioBricks devices can be characterized. To date most characterization work has been done in low or high copy vectors which have several issues including
- Copy number is uncertain or variable making it difficult to infer PoPS per DNA copy.
- At high copy, devices place a high metabolic load on the cell thereby altering host physiology and observed device behavior.
The proposed solution to these two problems is to characterize devices at single copy in the cell. Obviously, such a vector will vary between 1 and 2 copies per cell over the cell cycle but nevertheless will hopefully present an improvement over the current situation. The advantage of using a single copy plasmid rather than simply integrating the device into the genome is that a separate plasmid offers some isolation from the host and makes moving the device between different host strains slightly easier.
The F plasmid origin needs to be designed. The complete F plasmid with partitioning genes in ~10kb in length. It contains several BioBricks restriction sites in both coding and noncoding regions.
Once designed, the F plasmid origin can be assembled with an antibiotic resistance marker and cloned into the vector scaffold to generate a new single copy BioBricks plasmid.
- Can only be used in F- strains
- Should likely be used in recA- strains to avoid integration onto the genome and ensure plasmid stability.
- It is unclear whether this vector would truly be operating at single copy. If it is not, perhaps it is easier to stick with the pSB2* plasmids.
See notes on bacterial artificial chromosomes.
Vectors has a lot of general information on vectors.