Sack: Bead Cell Binding

From OpenWetWare

(Difference between revisions)
Jump to: navigation, search

Jon Sack (Talk | contribs)
(New page: 10mm dish cell scraping protocol<br> Materials:<br> (2x 10mm dish)<br> warm 5 ml EDTA DPBS (such as versene) for each plate<br> two 15 ml falcon tubes<br> (tube 1: saved media, tube2: sc...)
Next diff →

Revision as of 22:07, 10 October 2012

10mm dish cell scraping protocol

Materials:
(2x 10mm dish)
warm 5 ml EDTA DPBS (such as versene) for each plate
two 15 ml falcon tubes
(tube 1: saved media, tube2: scraped cells)

Objective

  • scrape two 70-90% confluent 10 cm dishes of Kv2.1 TREX cells incubated with1 ug/ml tetracycline for 24-48 hours (1 dish for every 2 tubes to be incubated with beads)
  • Perform the same procedure for 2x 10cm dishes of Empty CHO cells.
  • to re-suspend a dense amount of cells to plate with beads 5 and 180 K solution after appropriate incubation time

Procedure (for 2x 10cm dishes of a given cell type)

  • remove cell media from dishes and save in 15 ml tube
  • rinse cell plate with 5mL of EDTA DPBS, aspirate majority of solution leaving a thin layer of EDTA DPBS on cells
  • scrape entire plate surface area of cells
  • place all of scraped cells in a separate 15mL falcon tube (2)
  • rinse dishes with 5mL of their original cell media from tube (1), and add to cell mix
  • centrifuge tubes at 500g for 5 minutes; cells will pellet at bottom
  • remove supernatant from cell mix, careful not to remove cell pellet formed on bottom.
  • re-suspend cells in 4 ml of the supernatant media (tube 2) you've just spun down, triturate 10X to break up cell clumps, and transfer to 2x 2mL tubes
  • add beads ASAP, keep incubating at 37 degree water bath
Personal tools