Polyacrylamide gel electrophoresis

This procedure is useful for the separation of small pieces of DNA, small quantities of DNA, or applications where higher resolution than can be achieved with agarose gel electrophoresis is needed. Because it is very difficult to remove DNA from polyacrylamide gel, it is advised that this protocol should only be used for diagnostic purposes and not for size separation of useful fragments.

Materials

Reagents

• 29:1 Acrylamide Solution
• 10X TBE buffer
• Ammonium Persulfate
• TEMED
• DNA solution
• SYBR green
• Bromophenol Blue

Equipment

• Vertical electrophoresis chamber
• Glass plates w/ spacers (which fit the chamber)
• Casting holder
• Pipettors

Procedure

1. Place Glass plates in casting apparatus
2. Add together the following to make 5ml of gel (0.75mm spacers)

• 500µl 10X TBE solution
  
• 35µl Ammonium Persulfate (10%w/v)
  
• X mL 29:1 acrylamide solution (See the table under "notes" to determine the desired acrylamide concentration)
  
• Y mL water (To make 5 mL)
  
• 2µl TEMED
  

3. Pipet mix between casting plates using 5ml pipetor
4. Insert comb and allow to cure for 30 minutes
5. Mix the following for all DNA samples including the ladder

• 10μL DNA solution
  
• 1μL SYBR green (100X Dilution in DMSO)
  
• 1μL Bromophenol Blue
  

6. Remove comb, insert gel into electrophoresis chamber and add the necessary amounts of 1X TBE
7. Add DNA mix to wells.
8. Apply 80 volts and run for approximately 60 minutes

Critical steps

Referenced from the main protocol, a more thorough explanation of particularly important steps in the protocol.

Troubleshooting

Referenced from the main protocol, an explanation of what can cause things to go wrong with the protocol.

Notes

Referenced from the main protocol, any comments about the protocol should be made here; i.e. how it was developed. Any comments added should be signed (by adding *'''~~~~''': in front) and explained. Links to FAQs/tips provided by other sources such as the manufacturer or other websites would be best made here.
Anecdotal observations that might be of use to others can also be posted here; e.g. 'my cells were still floating'.

It might also be good to add an image to show the workflow and timescales for experiment planning.

Acknowledgments

Acnkowledge any help you had in development, testing, writing this protocol.

References

See OpenWetWare:Biblio for information on how to reference within a wiki.

Specific Protocols

Add links to all the OWW protocols that have been used in making the consensus.

Discussion

You can discuss this protocol.

Tag this page with categories to allow easier indexing and searching. See Categories for information on existing categories.