MIT:Sequencing BioBrick DNA
Back to Sequencing DNA
To confirm the physical DNA resulting from a BioBrick standard assembly step has the same sequence as that part in the registry, the physical DNA must be sequenced. This is done by the BioPolymers lab in the Cancer center.
Sequence Request and Sample Preparation
- Prepped plasmid for sequencing
- You may want to read the notes from the Biopolymers lab for optimizing your prepped DNA
- VF2 and/or VR1 verification primers (10x dilution especially for sequencing reactions)
- Sterile DI water
- Fill out the online submission form
- Print one sheet for your records, and bring one sheet with your tubes to the biopolymers lab.
- Make a 12 μL mix as specified in the submission form.
- From the 40μM stock solutions, you'll want 0.8μL of a 1:10 dilution of the stock.
- The sequencing request form is numbered. Put each mix into a PCR tube (if you have >4 samples, the sequencing center requests the use of PCR strips) and write the sample number from the form on the top of the tube.
- Deliver all the tubes and the form to the Bio Polymers lab in the Cancer Center. Go to the Cancer center, take the elevator to the 4th floor, take a right, it will be your 2nd-ish door on the left.
- The Biopolymers lab is room E17-415. Inside, there is a brown fridge with a clear plastic thing attached to the front. Put your request from in the clear plastic thing and your large eppendorf tube inside the fridge.
- When you arrive put all the small PCR tubes into a large falcon tube (there is a stash of used falcons next to the small fridge). Then label the side of the large falcon with your name, the date, and Knight Lab and the order number.
- Now you get to wait for your sequencing results to come back (usually 3-4 days). You should be notified by email when they are available. They are trying to reduce their turnaround time to 1 day.
Note that the Biopolymers lab is generally only open during normal business hours, Mon-Fri, 9-5.
Retrieve sequence data
Login to dnalims to retrieve sequence data.
Verify sequence data
One option is to use VectorNTI to align your expected sequences with the .abi data files generated by the sequencing center via the ContigExpress module.
The registry permits blasting against the parts database with the option of only blasting against basic parts. This can be a quick way to determine whether your sequence is right or not.
There are also various programs that the sequencing center recommends listed here.
The dnalims online software also permits sequence analysis. According to the sequencing center, it is quite good.