Koch Lab:Protocols/Kinesin/Tubulin resuspension and polymerization

Steve Koch 00:32, 3 May 2009 (EDT): I am unsure of the historical details of this protocol. It's the one I used in 2003 and 2004, adapted from George Bachand and probably from Susan Rivera and Andy Boal. They probably followed protocols from Cytoskeleton or the Kinesin Home Page, probably a Howard Lab protocol?

Introduction

This protocol assumes that tubulin has been purchased from Cytoskeleton. Various forms can be purchased. As of 5/2/09, the only two forms we are talking about are lyophilized un-labeled bovine tubulin and rhodamine-labeled bovine tubulin in a 10 mg / ml suspension.

Tubulin dimers are highly unstable, so care should be taken to keep as cold as possible and minimize warm steps except when polymerizing.

Non-labeled tubulin resuspension

1. Tube should contain 1 mg of tubulin.
2. Dissolve the tubulin in 180λ of cold GPEM buffer¹
3. Add 20 λ of cold cushion buffer²
4. Store @ -80C in convenient aliquots. I do 25λ aliquots in 100λ PCR thin-walled tubes.

¹ GPEM is 198λ of BRB80 plus 2λ of 100 mM GTP in 100 mM MgCl2
² I use cushion buffer from cytoskeleton (BST106), I think it is BRB80 w/ 60% glycerol

Rhodamine tubulin resuspension

1. Tube usually contains 2λ of a 10 mg / ml solution of tubulin in GPEM + cushion^{3, 4, 5}
2. Spin down several tubes (say 4 tubes) to get liquid to bottom of tube
3. Combine for total volume of say 8 λ.
4. Add 8 λ of GPEM + cushion [9 parts GPEM, 1 part cushion]
5. Store @ -80C in aliquots. I store 1 λ aliquots in 100λ PCR thin-walled tubes.

³ Make “GPEM+ Cushion” by mixing 9 parts GPEM with 1 part “Cushion” buffer.
⁴ GPEM is made by adding 2 λ of 100 mM Mg-GTP to 198 λ of BRB80
⁵ Steve Koch 00:42, 3 May 2009 (EDT): I found the following note in one of my protocols from 2003: "Note: The cytoskeleton storage buffer has the correct amount of GTP, but does not have glycerol. So adding 2λ to 2 λ actually does not produce the “correct” final glycerol concentration. This seems to be OK, though." Whereas above, I say that the storage buffer does have cushion (glycerol). So, I don't know the answer, but this should be easily answerable by contacting cytoskeleton.

Other references

This page was initially prepared based on my Word document notes from Sandia. Ultimately I'd love to have all of them converted to OWW. Until then, I'm manually uploading a few to GoogleDocs. Here's two used to prepare this page:

• http://docs.google.com/Doc?id=dgqjkh6p_83dz57zchd
• http://docs.google.com/Doc?id=dgqjkh6p_84fbwgcgf8