Part III: Building Your First Model: A --> B --> C
In this section, you will build your first model from scratch with CellDesigner, and you will learn to run a simulation.
The model explored describe a system where a compound 'A' is transformed into a compound 'B', which is consequently transformed into a compound 'C'.
To start, launch the CellDesigner Application: Double Click on the Icon found on your Desktop.
Then follow the instructions below to build the model.
How do A, B and C, change with time using these default parameters?
Now swap the values of k1 and k2 (k1=10 and k2=1)under the parameters tab
How does this alter the formation of C?
How does B change?
Explain these results
If you had real life data showing the accumulation of C for an A-B-C reaction you could fit the data using this model and two rate constants would be returned. Could you assign these rate constants to k1 or k2 (yes or no)?
What additional data would you need to assign k1 and k2?
An enzyme converts a substrate into a product, this is usually an irreversible reaction and is treated as such in the Michaelis-Menten model. An enzyme reaction constitutes a dynamic process and can be studied as such. One may look at the time courses of the reactants, or look at the steady-states and their stability properties.
This part of the tutorial deals with well-known Michaelis-Menten formula.
Here, we will focus on comparing the Michaelis-Menten approximation to the full enzymatic reaction network.
From the ODE system description, create all the necessary kinetics reactions in the network provided. We will be considering k1 = 105M − 1s − 1,k2 = 1000s − 1,k3 = 10 − 1s − 1,[E]t = 0 = 0.01M,[S]t = 0 = 0.1M,[P]t = 0 = 0
Open the Simulation Panel, set Time=150, NbPoints=1000.
Run a simulation, and comment on the different phases during the product formation. Pay special attention to the formation and decay of the [ES] complex. Note that this is a full simulation of the reaction scheme and so does not rely on any assumptions.
We want now to investigate the Michaelis-Menten approximation. Show that under the assumption that the complex [ES] is at steady-state (), we can write: . (Note that [E]t = 0 = [E]t + [ES]t). Also, make sure that the concentration of the substrate is at least 10 fold greater than the concentration of the enzyme.
Express (Km and Vmax) with regards to k_1, k_2, k_3 and [E]0; see the links below on how the Michaelis-Menten equation is derived if you are not sure.
Now create a new reaction in CellDesigner(as shown above)with an Enzyme that acts on the reaction. Define the maths for this reaction based on the above form of the Michaelis Menten equation. Make sure that both models are equivalent with regards to their parameters.
Run simulations, and comment on the differences observed between the full model, and the Michaelis-Menten approximation.