Haynes Lab:Notebook/Synthetic Biology and Bioinformatics for Predictable Control of Therapeutic Gene2/2012/08/29

Digestion

• We usually use ECO-R1 or PST-1 to cut (refer to Dr. Hayes Biobrick cloning 12/16/09)
• Part: BBa_J176122, Vector: MV2, Transfection Plasmid: KAH126

Reagent	Volume	Master Mix	Expected	Expected: KAH126 = 1880bps MV2 = 4529bps	15 μL/lane; 1% agarose	Gene Ruler
DNA(plasmid)	3.0 μL	-
10X buffer	1.5	4.5
EcoRI	1.0	3.0
PstI	1.0	3.0
dH2O	8.5	25.5

• Use two 0.5mL tubes for single tubes and a 1.5ML tube for the MM

1. Aliquot 12uL to each 0.5mL tube
2. Add 3 uL of DNA to each
3. Incubate @ 37C/>10min

How to make a gel:

1. 60mL of TAE and 0.6g of agarose, swirl
2. 40s in the microwave, swirl
3. 40s in the microwave, swirl
4. 6mL of Ethidium Bromide

• Note: Wash flask immediate

Moving onto the box

• If there is TAE buffer in the electrophoresis, put box in a casting tray
• Use B14 teeth (thinner side, thicker side is for dilute DNA). We had 2 rows.
• Check for bubbles in wells and push them out of the wells if needed

Gel Electrophoresis Procedure

• It takes 15-20 min for the gel to solidify
• At 70V is takes about 1hr for the gel to run
• Gel is done solidifying when it's translucent

1. Grab comb out from both sides
2. Put in runner
3. Add 10uL of Ethidium Brodmide to TAE at positive end (the end facing you)
4. 1KB+ loading dye (blue) > 10uL of ladder > 15uL of sample
5. Pour off extra liquid and set gel on a paper towel
6. Slide gel off onto UV light
7. Put gel in waste box
8. SIZES! Compare to expected (MV2, HPCD...) > 2 bands