Haynes:LBliquidmedia

From OpenWetWare

(Difference between revisions)
Jump to: navigation, search

Rene M Davis (Talk | contribs)
(New page: =LB Liquid Media= by Karmella Haynes, 2012<br><br> MATERIALS * Personal Protective Equipment (PPE) - lab coat, disposable gloves * LB Broth powder (Sigma L3022) * 1N NaOH * Two clean and...)
Next diff →

Revision as of 17:23, 10 October 2013

LB Liquid Media

by Karmella Haynes, 2012

MATERIALS

  • Personal Protective Equipment (PPE) - lab coat, disposable gloves
  • LB Broth powder (Sigma L3022)
  • 1N NaOH
  • Two clean and sterile 1000 mL glass flasks


PROCEDURE

Make LB - these instructions are for 1 liter

  1. Put on your PPE.
  2. Fill a 1000 mL graduate cylinder with deionized water (from the sink)
  3. Weigh out 20 g of LB Broth powder on the balance.
  4. Add the LB powder to the water in the cylinder.
  5. Weigh out 15 g of Bacteriological Agar.
  6. Add the Bacteriological Agar to the mixture in the cylinder.
  7. Use a 1000 μL micropipette to add 1000 μL 1N NaOH to the mixture.
  8. Swirl the mixture for a few seconds.
  9. Fill the cylinder up to 1000 mL with deionized water (from the sink).
  10. Get two clean, sterile 1000 mL glass flasks from the shelf. Remove the foil caps and set them aside
  11. Carefully cover the cylinder with a large square of parafilm. Make sure the seal is tight.
  12. Cover the opening with your gloved hand and invert the cylinder several times to mix the solution.
  13. Quickly and carefully fill each flask up to the 300 mL mark. Cover the cylinder again and invert to mix.
  14. Quickly and carefully fill each flask up to the 400 mL mark. Swirl the cylinder to mix.
  15. Quickly and carefully fill each flask up to the 500 mL mark.

Melt the LB Agar

  1. OPTION 1 - Microwave
    1. Replace the foil caps with Kimwipe-covered black foam plugs.
    2. Carry the flasks (in a tray) to the large white microwave (Wang Lab).
    3. Microwave the flasks for 5 minutes. Use a rubber mitt to swirl the flasks (to remove trapped air).
    4. Microwave the flasks for another 5 minutes. Use a rubber mitt to swirl the flasks (to remove trapped air).
    5. Microwave the flasks for10 minutes. Use a rubber mitt to put the flasks back into the tray and bring them back to your bench
  2. OPTION 2 - Autoclave
    1. Put the foil caps on the flasks.
    2. Put the flasks in an autoclave tray. Fill the bottom of the tray about 1 inch deep with tap water (this trick prevents boil-over).
    3. Take the tray with flasks up to the 3rd floor autoclave.
    4. Choose the "Liquid 15" program/cycle. Put the tray with flasks into the autoclave, close the door, and hit "start".



</div>

Personal tools