Endy:Screening plasmid

This page is a work in progress.

Introduction

Schematic of the screening plasmid design.

The screening plasmid is designed to enable fast characterization of PoPS-based parts and devices. It consists of 4 components: (1) Tunable input (2) Input measurement (3) Part/Device insertion site (4) Output measurement.

Screening Plasmid 1.0

Design of Screening Plasmid 1.0: We are using the Pbad arabinose-inducible induction system [2] as a tunable input. GFP is a measure of input and RFP is a measure of output. A Biobricks cloning site enables easy insertion of any Biobricks part. RNase E sites create independence between the mRNA stability of the device being screened and the mRNA stability of the fluorescent proteins. In particular, we suspect mRFP1 contains internal RNaseE cut sites and have added a hairpin 5’ of the coding region to slow degradation by RNase E. [3]

• Background
• Protocols
• Status
• Constructs

Terminator Characterization via Screening Plasmid 1.0

• Protocols
• Analysis

Inverter Characterization via Screening Plasmid 1.0

Characterization of Q04740: Dot plot of one replicate is shown in upper right. Mean RFP expression for 3 replicates is plotted against GFP showing characteristic inverter transfer curve.

• Protocols
• Inverters

Screening Plasmid 2.0

We are in the process of designing a new version of the screening plasmid to account for some of the shortcomings of the previous version. An early list of possible improvements:

1. Brighter FPs (in particular RFP is very dim)
2. Lower copy plasmid

References

[2] Khlebnikov et al,Modulation of gene expression from the arabinose-inducible araBAD promoter. J Ind Microbiol Biotechnol. 2002 Jul;29(1):34-7.

[3] Effect of gene location, mRNA secondary structures, and RNase sites on expression of two genes in an engineered operon. Biotechnol Bioeng. 2002 Dec 30;80(7):762-76.