Designing primers

From OpenWetWare

Revision as of 06:42, 24 August 2005 by Reshma P. Shetty (Talk | contribs)
Jump to: navigation, search

Contents

General guidelines

  • Avoid runs over 3 nucleotide (AAAA)
  • 18-30bp in length. Molecular Cloning says that 5' tails do not significantly affect annealing.
  • Primer pairs should differ in length by less than 3bp.
  • 3’ end should be G or C (stronger bond)
  • Primer melting temp (Tm) should be 50-60°C with low FIR difference (<5°C, <2°C better)
  • Molecular Cloning advises GC content between 40% and 60%
  • Avoid palindromes and inverted repeat sequences.
  • Avoid complementarity between members of a primer pair.
  • Check for dimer binding and hairpins in Vector NTI.
    • Want to avoid structures with ΔG < -5kcal/mol
  • Long primers (those approximately >50 bp or those needed for sensitive applications) should be purified. Note that the purification step costs extra. See the Invitrogen FAQ on purification options for more information on which purification method to choose.
  • Verify that your primers are designed and ordered in the correct orientation (oligos are always specified 5' to 3', left to right).
  • If you plan to cut your PCR product near the ends of the linear DNA fragment, note that some enzymes do not cut efficiently at the ends of linear DNA. So include extra bases to increase the efficiency of cutting. Many enzymes work with 4 bases supposedly but XhoI was found to require more than 4 bases (8 bases was used successfully). Thus, to be on the safe side, use 8 bases whenever possible. NEB has more information here. Read the information at NEB carefully ... they recommend adding 4 bases to the numbers listed in their table.
  • Tom's rule of thumb is that if a PCR fails, try it again. The second time around, work a bit harder by varying the annealing temperature or something else. If it fails again, redesign your primers.

BioBrick primers

To BioBrick a part, the following tails should be added to your primers:

  • PREFIX Primer cctttctagag 11 bp
  • SUFFIX Primer tactagtagcggccgctgcagcctt 25 bp

The prefix primer adds an Xba I site, and the suffix adds the entire BB suffix (Spe I-Not I-Pst I)

Check the annealing temperature both without the tail (the first cycle or so) and with the tail (the later cycles).

Resources

Useful primer design tools

Oligo synthesis information

Personal tools