Design a Microfluidic Chip
From OpenWetWare
(Difference between revisions)
Current revision (22:57, 28 October 2010) (view source) |
|||
| (3 intermediate revisions not shown.) | |||
| Line 1: | Line 1: | ||
| - | The process of designing a microfluidic chip to be ordered from the [http:// | + | The process of designing a microfluidic chip to be ordered from the [http://kni.caltech.edu/foundry/ Caltech Foundry ] is not hard but it is a little involved. |
==Steps== | ==Steps== | ||
| Line 12: | Line 12: | ||
| - | [[Category: | + | [[Category:Protocol]] [[Category:Microfluidics]] |
Current revision
The process of designing a microfluidic chip to be ordered from the Caltech Foundry is not hard but it is a little involved.
Steps
- Learn the design rules
- Make a rough outline of your chip design
- This should be influenced by previous designs as well as constraints of the design rules
- gain a (rudimentary) understanding of AutoCAD
- Create a schematic of your chip in autoCAD
