|
|
(2 intermediate revisions by the same user not shown) |
Line 1: |
Line 1: |
| =How to Create a PDMS-Stamp from Silicone/Araldite Mold=
| |
|
| |
|
| ==Preparation of PDMS mixture==
| |
| * with pipette boy and 5ml stripette pour ~4g of elastomer into a (clean) cup
| |
| * with micropipette (1000µl) add one tenth of elastomer mass (~0.4g) of linker fluid to the cup
| |
| * mix well with stripette
| |
| * degass for 30min-60min
| |
|
| |
| ==Preparation of PDMS membrane==
| |
| * pour degassed mixture onto wafer placed in petri dish with aluminium foil
| |
| * pour just enough to cover the waver
| |
| * use [[Christian Niederauer/Notebook/RacingBacteria/Stock/Leveling_Petri_Dish | Leveling Petri Dish]] to ensure constant thickness
| |
| * araldite wafer: cure it for 3-4 hours in oven at 60°C
| |
| * silicon wafer: cure it for 2 hours in oven at 80°C for
| |
| * peel off membrane from wafer surface with forceps
| |
| * cut out the pattern but '''leave enough space around it'''
| |
|
| |
| ==Final Processing==
| |
| * punch holes with 2mm coring tool at the desired connection points under dissection microscope (tip: target the hole with coring tool under microscope, then put the stamp onto one finger with alufoil between stamp and finger and push/turn until you feel the coring tool on your skin)
| |
| * [[Christian Niederauer/Notebook/RacingBacteria/Protocols/Plasma_Cleaning | plasma clean]] the treated face of the stamp and a coverslip and press them together with alufoil in order to prevent contamination
| |
|
| |
|
| |
| ===If the stamp is too thin===
| |
| '''BEFORE PUNCHING HOLES'''
| |
| * take a slice of PDMS with bigger or same area than the stamp
| |
| * [[Christian Niederauer/Notebook/RacingBacteria/Protocols/Plasma_Cleaning | plasma clean]] unshaped face of stamp and extra slice and stick them together
| |
| * now punch desired holes with 2mm coring tool
| |