Beauchamp:IfCortModExists

From OpenWetWare

Revision as of 16:32, 9 April 2008 by Molly A Bryan (Talk | contribs)
(diff) ←Older revision | Current revision (diff) | Newer revision→ (diff)
Jump to: navigation, search

What if I have scanned a subject for whom a surface model already exists?

Automation

All of the steps below are contained in the scripts file /Volumes/data9/surface/scripts/@alreadymade

To run this command type,

 /Volumes/data9/surfaces/scripts/@alreadymade current_ec subjname original_surface_ec

Where current_ec is the current two-letter experiment code subjname is the subject's name in the format lastname_firstname. original_surface_ec is the two letter experiment code which the surface was originally constructed from (this must be determined by looking in the surfaces directory)

Aligning to Experiment

The scripts assumes that all of the steps performed the script file @prep_dir have been performed (see Preparation for Creating Cortical Surface Models page) e.g.

 /Volumes/data9/surfaces/scripts/@recon BD doe_jane

First, check to make sure that the already created surface has the necessary components created by the @finish script

 FSread_annot -input ../label/lh.aparc.a2005s.annot -roi_1D ./lh.aparc.a2005s.1D.roi
 FSread_annot -input ../label/rh.aparc.annot -roi_1D ./rh.aparc.1D.roi
 FSread_annot -input ../label/lh.aparc.annot -roi_1D ./lh.aparc.1D.roi
 mris_convert -c ../surf/lh.sulc ../surf/lh.smoothwm ./lh.sulc.asc
 mris_convert -c ../surf/rh.sulc ../surf/rh.smoothwm ./rh.sulc.asc
 set ec = TA203
 SurfSmooth -spec {$ec}_both.spec -surf_A lh.smoothwm.asc -met NN_geom -surf_out lh.smoothwm.SS500.ply -Niter 500 -match_area 0.01
 SurfSmooth -spec {$ec}_both.spec -surf_A rh.smoothwm.asc -met NN_geom -surf_out rh.smoothwm.SS500.ply -Niter 500 -match_area 0.01
 cp /Volumes/data9/surfaces/scripts/both.spec ./both.spec

Next, go to the surfaces directory, create a copy of the new anatomy, and align it the new data with the old surface model.

 3dcopy  /Volumes/data1/UT/CZ/afni/CZanatr1+orig ./CZanatr1
 @SUMA_AlignToExperiment -exp_anat CZanatr1+orig -surf_anat TA203_SurfVol+orig -prefix CZ_SurfVol_Alnd_Exp 
 mv CZ_SurfVol_Alnd_Exp+orig.* /Volumes/data1/UT/CZ/afni/

Next, create an @EC file that points to the appropriate directory:

 cat >> @CZ
 /Volumes/data9/surfaces/scripts/@ec  CZ /Volumes/data9/surfaces/TandonLang/TA203/SUMA
Personal tools