Addition of 3' A overhangs to PCR products
|Line 53:||Line 53:|
Revision as of 00:00, 19 October 2008
If PCR is performed using a proofreading DNA polymerase, such as Pfu DNA polymerase, the product will have blunt ends. Taq DNA polymerase catalyzes the non-template directed addition of an adenine residue to the 3´-end of both strands of DNA molecules to make it suitable for TA cloning.
- Purified PCR product
- PCR buffer with Mg
- Taq DNA Polymerase
- Thermocycler or Heat block equilibrated at 72°C
2. Prepare Taq DNA polymerase reaction mix for a typical 20 - 50 μl reaction:
|Purified PCR product||0.15 to 1.5 pmol||variable|
|dATP (10 mM)||0.2 mM||1|
|PCR Buffer with Mg (10x)||1x (1.5 mM MgCl2)||5|
|Taq DNA Polymerase (5 U/μl)||1U||0.2|
|ddH2O||-||up to 50 μl|
The A-addition reaction works best when a specific amount of the PCR product is used. The recommended amount is 10–100 ng PCR product for each 100 bp length of the PCR product. This corresponds to 0.15–1.5 pmol PCR product (see table below).
|PCR product size||Amount of PCR product to use|
|100 bp||10–100 ng|
|250 bp||25–250 ng|
|1000 bp||100–1000 ng|
3. Incubate 20 min at 72 °C.
4. Proceed to TA cloning. For optimal ligation efficiency, it's best to use fresh PCR products, since 3´A-overhangs will gradually be lost during storage.
Before adding the overhangs it is very important to remove all the Proofreading DNA Polymerase (Pfu) by purifying the PCR product carefully (e.g. with a commercial PCR purification kit or phenol extraction and DNA precipitation) ; since the proofreading activity of DNA Polymerase will degrade the A overhangs, creating blunt ends again.
Acnkowledge any help you had in development, testing, writing this protocol.
See OpenWetWare:Biblio for information on how to reference within a wiki.
Add links to all the OWW protocols that have been used in making the consensus.
You can discuss this protocol.
Tag this page with categories to allow easier indexing and searching. See Categories for information on existing categories.