AU Biomaterials Design Lab:Protocols/Quantum Northwest Cuvette Holder: Difference between revisions
From OpenWetWare
Jump to navigationJump to search
(New page: ==Description== The Quantum Northwest Cuvette Holder temperature controller, is able to maintain a specific temperature for your cuvette over the course of an experiment and can also provi...) |
No edit summary |
||
Line 3: | Line 3: | ||
==Protocol== | ==Protocol== | ||
# | # Fill the clear 8 quart/7.5 L bucket 3/4 full with water | ||
# Make sure that the aquarium pump is properly connected and inside of the bucket. Plug in the pump. | |||
# Plug in the cuvette controller | |||
# | # Make sure the computer is turned on | ||
# Open the "Q Blue Wireless Temperature Controller" by clicking its icon on the desktop | |||
# Set the Temperature | |||
## Set the Control Status to "On" | |||
## Input your desired temperature | |||
### Click "Change" for the Target Temperature and type in the temperature you want for the experiment | |||
### For most nanoparticle syntheses, the temperature is 80C | |||
# Set the stirring | |||
# | ## If you need stirring, and have a stir bar in your cuvette, set the stirrer to "On" | ||
# | |||
# | |||
## | |||
# | |||
## Click | |||
## | |||
==Notes== | ==Notes== |
Revision as of 13:02, 24 August 2016
Description
The Quantum Northwest Cuvette Holder temperature controller, is able to maintain a specific temperature for your cuvette over the course of an experiment and can also provide a magnetic stirring function, should you need it. This instrumentation is coupled to the Ocean Optics spectrophotometer found in Beeghly 203B and is maintained by Dr. Hartings.
Protocol
- Fill the clear 8 quart/7.5 L bucket 3/4 full with water
- Make sure that the aquarium pump is properly connected and inside of the bucket. Plug in the pump.
- Plug in the cuvette controller
- Make sure the computer is turned on
- Open the "Q Blue Wireless Temperature Controller" by clicking its icon on the desktop
- Set the Temperature
- Set the Control Status to "On"
- Input your desired temperature
- Click "Change" for the Target Temperature and type in the temperature you want for the experiment
- For most nanoparticle syntheses, the temperature is 80C
- Set the stirring
- If you need stirring, and have a stir bar in your cuvette, set the stirrer to "On"